Rolling back into history
The problem for anyone who wanted to read the document was that in order to open up the petition, the entire length needed to be unrolled first. Once unrolled, there was the issue of trying to safely open a 13 metre fold! Most of the pages were in relatively good condition, but there were signs of wear and strain due to the way it had been constructed. What was required was to repair the tears and relieve some of the inherent tension, and then to come up with an adequate storage solution.
Because the petition is made up of sheets of paper of varying sizes, getting it all to fit had inherent problems. Slightly larger sheets would be loose and liable to crease when they were stuck to a smaller sheet, whereas the smaller sheet would potentially tear. Also, some of the signatures were pasted underneath corresponding sheets.
The petition was unrolled along a cleared corridor and then three conservators carefully unfolded it. It was then rolled back onto a large cardboard cylinder, where it could be un-wound a little at a time for repair.
Most of the pasted pages needed to be released and re-aligned. Animal glue swells and softens with water, but care must be taken as too much moisture can create further stains or make soluble inks run.
Water was introduced through a membrane that allowed better control over the moisture penetrating the document. The paste eventually swelled and softened enough to be able to lift the pages and re-attach.
Once released, excess animal glue was cleaned and where needed, the pages were flattened and repaired. Then they were finally re-attached using repair tissue and wheat-starch paste. The newly repaired section of the scroll was rolled on a bit further and the repair process continued.
One aspect of being only able to work on a small section at a time was that it made it very difficult to judge the overall alignment of the scroll. Adjusting all of those pages did not make it easy to roll the petition neatly. To give it some room to move, it was inter-leaved with a length of Remay tissue (spun polyester) and loosely rolled onto a cardboard cylinder. A new box was made where the weight of the petition could be held by the edges of the cylinder and not the actual document.
The treatment resulted in the petition moving from within a relatively small file to rehousing it into a rather large and complicated box. Still, at least we can now read what it has to say. And for the record, it seems that the appeal did not work and William Spicer was forced to remain in prison.
This content was first published on our Archives Outside blog in 2011.